Science and nature · Earth science

How earthquakes happen — and why Pakistan sits on some of the world's most active fault lines

Pakistan experiences hundreds of earthquakes every year. Most are too small to feel. But the country sits at the junction of three massive tectonic plates, making it one of the most seismically active places on Earth. Here's the science behind why the ground shakes — and what makes some earthquakes so much more destructive than others.

Published 21 November 2026 · 7-minute read

In short

  • The Earth's surface is made of giant slabs of rock called tectonic plates. They move a few centimetres a year — and when they grind against each other, they release energy as an earthquake.
  • Pakistan sits where the Indian, Eurasian and Arabian plates collide. This is what built the Himalayas, the Karakoram and the Hindukush — and it is what makes Pakistan so earthquake-prone.
  • Magnitude measures energy, not shaking. Each step up on the scale releases about 32 times more energy — a magnitude 7 earthquake releases roughly 1,000 times more energy than a magnitude 5.
  • The 2005 Kashmir earthquake (magnitude 7.6) killed around 87,000 people. Its depth, location above a fault, and the construction of local buildings were the main reasons it was so deadly.

The Earth is not solid all the way through

It is easy to think of the ground as fixed and permanent. It is not. The Earth's outer layer — called the crust — is broken into about 15 large pieces and several smaller ones, called tectonic plates. Beneath the crust is the mantle, a layer of rock so hot that over millions of years it flows very slowly, like extremely thick treacle. The plates sit on top of this flowing mantle and are carried along with it, moving a few centimetres every year — roughly as fast as your fingernails grow.

Most of the time you cannot feel them move. But where two plates meet, enormous pressure builds up over decades and centuries. The rocks on either side of the boundary lock together and bend under the stress — until one day they slip suddenly. That slip releases the stored energy in seconds as an earthquake.

What actually happens underground

The point underground where the rock first breaks and slips is called the focus (or hypocentre). The point directly above it on the surface is the epicentre — the location you see reported in the news. The closer the focus is to the surface, the more shaking is felt above it. A shallow earthquake (focus less than 70 km down) is typically more destructive than a deep one of the same magnitude, because the energy has less rock to travel through before reaching buildings and people.

The energy radiates outward from the focus as seismic waves. There are two main types:

After the main earthquake, smaller aftershocks follow as the rock settles into its new position. Some aftershocks are strong enough to collapse buildings already weakened by the main event — which is why rescue workers approach damaged structures with extreme caution.

Why Pakistan is so vulnerable

Pakistan sits at one of the most geologically dramatic collision zones on Earth: the place where the Indian plate is ramming into the Eurasian plate from the south, while the Arabian plate pushes in from the southwest.

This collision is not new. Around 50 million years ago, the landmass that is now the Indian subcontinent — once a separate island-continent adrift in the ancient Tethys Ocean — began colliding with Eurasia. The impact crumpled the edge of both plates upward, forming the highest mountain ranges on Earth: the Himalayas, the Karakoram and the Hindukush. K2 and Nanga Parbat — two of Pakistan's giants — are still being pushed upward by a few millimetres every year.

That collision is ongoing. The Indian plate is still moving north at about 40–50 mm per year, and the pressure it generates must go somewhere. It goes into earthquakes. Pakistan's main fault systems include:

Karachi, sitting near the Chaman Fault system, is not as far from seismic risk as many assume. And the northern areas — AJK, KP, Gilgit-Baltistan — sit directly on some of the most active fault systems in the world.

How magnitude is measured — and why it matters

When you hear that an earthquake measured 5.5 or 7.6, that is its magnitude — a measure of the energy released at the source. The scale is logarithmic, which means each whole number represents roughly 32 times more energy released, not 10 times more shaking as people often assume.

In practical terms:

Magnitude alone does not predict how deadly an earthquake will be. What matters equally is depth (shallow earthquakes shake the surface more), proximity to populated areas, local geology (soft sediment shakes more than hard rock), and critically, the quality of local buildings.

The 2005 Kashmir earthquake — what it teaches us

On 8 October 2005, at 8:50 in the morning, a magnitude 7.6 earthquake struck the region around Muzaffarabad in Azad Kashmir. It was shallow — the focus was only about 15 km underground — and it struck directly above the Main Boundary Thrust fault.

Around 87,000 people were killed, more than 3.5 million were left homeless, and entire towns — Balakot, Muzaffarabad, Bagh — were largely destroyed. It remains the deadliest natural disaster in Pakistan's recorded history.

The death toll was not inevitable. It was shaped by several compounding factors:

The lesson from 2005 is not that we cannot stop earthquakes — we cannot. But we can build buildings that do not collapse when the ground shakes. Countries like Japan experience earthquakes of similar magnitude regularly and lose far fewer lives, because earthquake-resistant construction is enforced. This is ultimately a policy problem as much as a scientific one.

Can we predict earthquakes?

Not yet — and probably not in the way most people imagine. Scientists can identify which regions are at high risk and estimate the probability of a large earthquake over a 50-year period. But predicting a specific earthquake — giving the day, the location and the magnitude — has not been achieved reliably anywhere in the world despite decades of research.

What we can do is early warning. Because P-waves travel faster than S-waves, there is a small window — sometimes just a few seconds to a minute — between detecting the first P-waves and the arrival of the more destructive S-waves. Japan's earthquake early warning system uses this gap to automatically stop bullet trains, alert smartphones and trigger emergency shutdowns of industrial machinery. Pakistan has started developing similar systems, though coverage and reliability remain limited.

The most reliable protection is not prediction but preparation: earthquake-resistant buildings, enforced building codes, public education about what to do when the ground starts shaking, and disaster response systems that can reach remote mountain communities quickly.

What to do when an earthquake strikes